| xPC Target | |
Scaling Input to Output
| Hardware Input |
Block Output Data Type |
Scaling |
| volts |
double |
1 |
Driver Block Parameters
Number of channels -- If you choose 16 single-ended from the MUX list, then enter a number between 1 and 16. If you choose 8 differential from the MUX list, then enter a number between 1 and 8. This driver does not allow you to select individual channels or to mix single-ended and differential inputs.
Number the channels beginning with 1 even if the board manufacturer starts numbering channels with 0.
Range -- From the list, choose either +-10V (-10 to +10 volts), +-5V (-5 to +5 volts), or 0-10V.This driver does not allow you to select a different range for each channel. The input range is the same for all A/D channels.
The input range setting must correspond to the settings of jumper J6 and J9 on the board.
MUX -- From the list, choose either 16 single-ended or 8 differential. This choice must correspond to the MUX-switch setting on the board.
The differential mode is only supported if the board is equipped with option 1A. The MUX setting must correspond to the settings of jumper J3 and J7 on the board.
Sample time -- Base sample time or a multiple of the base sample time.
Base address -- Enter the base address of the board. It is important that this entry corresponds to the DIP-switch settings on the board. For example, if the base address is 300 (hexadecimal), enter
| | GESADA-1 | GESADA-1 Analog Output (D/A) | |