xPC Target

DA12-16(PCI) Analog Output (D/A)

Scaling Input to Output

Hardware Output	Block Input Data Type	Scaling
volts	double	1

Driver Block Parameters

Channel vector -- Enter a vector of numbers to specify the output channels. For example, to use the first and second analog output (D/A) channels enter

• [1, 2]
  

The channel numbers can occur in any order. Number the channels beginning with 1 even if the board manufacturer numbers them beginning with 0. The maximum allowable channel number is 16.

Reset vector -- The reset vector controls the behavior of the channel at model termination. Enter a scalar or a vector that is the same length as the channel vector. If you specify a scalar value, that setting is used for all channels. If you specify a value of 1, the corresponding channel is reset to the value specified in the initial value vector. If you specify a value of 0, the channel remains at the last value attained while the model was running.

Initial value vector -- The initial value vector contains the initial voltage values for the output channels. Enter a scalar or a vector that is the same length as the channel vector. If you specify a scalar value, that value is the initial value for all channels. The channels are set to the initial values between the time the model is downloaded and the time it is started.

Sample time -- Enter the base sample time or a multiple of the base sample time.

PCI slot -- If only one board of this type is physically present in your target PC, enter

• -1
  

Otherwise, enter the PCI slot number of the particular board to be controlled by this block. To find the slot number, use the command

• getxpcpci all
  

The Device ID of this board is 8163.

Contec DA12-16(PCI)

Contec PIO-32/32T(PCI)