| xPC Target | |
Scaling Input to Output
| Hardware Input |
Block Output Data Type |
Scaling |
| volts |
double |
1 |
Driver Block Parameters
Number of Channels -- Enter a number between 1 and 8 to select the number of A/D channels used. This driver does not allow the selection of individual channels.
Number the channels beginning with 1 even if the board manufacturer starts numbering the channels with 0.
Input Range -- Enter an input range code for all A/D channels. This driver does not allow the selection of a different range for individual channel. The input range is the same for all A/D channels
The following table is a list of the ranges for this driver and the corresponding range codes.
| Input Range (V) |
Range Code |
Input Range (V) |
Range Code |
| -10 to +10 |
-10 |
0 - 10 |
10 |
| -5 to +5 |
-5 |
0 - 5 |
5 |
| -2.5 to +2.5 |
-2.5 |
The jumpers W1 to W5 on the module must correspond to this range setting.
Sample time -- Enter a base sample time or a multiple of the base sample time.
Module Number (1-3) -- Enter a number from 1 to 3 to identify the connector on the carrier board where the I/O module is inserted. This driver verifies if the module is placed on the specified module connector.
Base Address of Carrier Board (ie. 0xd000) -- Enter the base address of the board. This entry must correspond to the DIP-switch settings on the board. For example, if the base address is 300 (hexadecimal), enter
Other jumper on this board. The switch and jumper settings, that are not mentioned here, have no influence on the running of xPC Target.
| Jumper Number |
Jumper |
Jumper Number |
Jumper |
| W6 |
out |
W22 |
out |
| W8 |
in |
W27 |
out |
| W10 |
out |
W30 |
- |
| W11 |
in |
W31 |
- |
| W12 |
out |
| | PCI-20019M | PCI-20023M | |