xPC Target

CAN FIFO Driver Blocks for the CAN-AC2-104 with Philips SJA1000 CAN-Controller

The driver blocks described here support the CAN-AC2-104 (PC/104) using FIFO mode. The Philips SJA1000 chip is used as the CAN controller in this configuration and supports both Standard and Extended identifier ranges in parallel. The driver block set for this board is found in the xPC Target I/O block library in the group CAN/Softing.

The fourth block group highlighted above contains the FIFO Mode sub group.

The highlighted group then contains all driver blocks available for FIFO Mode CAN.

FIFO Reset RCV Driver Block

FIFO Setup Driver Block