| Embedded Target for Texas Instruments C6000 DSPs | |
Configuration Information
To determine whether the Embedded Target for TI C6000 DSP is installed on your system, type this command at the MATLAB prompt.
When you enter this command, MATLAB displays the C6000 block library containing the following libraries that comprise the C6000 library:
If you do not see the listed libraries, or MATLAB does not recognize the command, you need to install the Embedded Target for TI C6000 DSP. Without the software, you cannot use Simulink and Real-Time Workshop to develop applications targeted to the TI boards.
| Note For up-to-date information about system requirements, refer to the system requirements page, available in the products area at the MathWorks Web site (http://www.mathworks.com). |
To verify that CCS is installed on your machine, enter
at the MATLAB command line. With CCS installed and configured, MATLAB returns information about the boards that CCS recognizes on your machine, in a form similar to the following listing.
Board Board Proc Processor Processor Num Name Num Name Type --- ---------------------------------- --- ------------------------------- 1 C6xxx Simulator (Texas Instrum ... 0 6701 TMS320C6701 0 C6x11 DSK (Texas Instruments) 0 CPU TMS320C6x1x
If MATLAB does not return information about any boards, revisit your CCS installation and setup in your CCS documentation.
As a final test, launch CCS to ensure that it starts up successfully. For the Embedded Target for TI C6000 DSP to operate with CCS, the CCS IDE must be able to run on its own.
| | Organization of the Document | Typographical Conventions | |