Embedded Target for Texas Instruments C6000 DSPs

Confirming Your C6701 EVM Installation

Texas Instruments supplies a test utility to verify the operation of the board and its associated software. For complete information about running the test utility and interpreting the results, refer to your TMS320C6201/6701 Evaluation Module User's Guide.

To run the C6701 EVM verification test, complete the following steps after you install your board:

1. Launch CCS.
2. Select Start -> Programs -> Code Composer Studio -> EVM Confidence Test. As the test runs, the results appear on your display.

1. By default, the test utility does not create a log file to store the test results. To specify the name and location of a log file to contain the results of the confidence test, use the command line options in CCS to run the confidence test utility. For further information about running the verification test from a DOS window and using the command line options, refer to TMS320C6201/6701 Evaluation Module User's Guide.

3. Review the test results to verify that everything works. Check that the options settings match the settings listed in Setting C6701 EVM User Option DIP Switches for the Embedded Target for TI C6000 DSP.

1. If your options settings do not match the listed configuration, reconfigure your C6701 EVM. After you change your board configuration, rerun the verification utility to check your new settings.

Configuring Your C6701 EVM

Testing Your C6701 EVM