Embedded Target for Texas Instruments C6000 DSPs

Real-Time Workshop Options for C6000 Hardware

The Real-Time Workshop pane of the Simulation Parameters dialog lets you set several options for the real-time model. To open the Simulation Parameters dialog, select Simulation -> Simulation Parameters from the menubar in your model. The following figure shows the Real-Time Workshop categories when you are using the Embedded Target for TI C6000 DSP.

On the Real-Time Workshop pane, the Category list provides access to the options you use to control how Real-Time Workshop builds and runs your model. Nine sets of options for configuring Real-Time Workshop target builds make up the categories--the first four apply to all RTW targets and always appear on the list.

The last four categories in the list shown are specific to the Embedded Target for TI C6000 DSP target ti_C6000.tlc and appear when you select the TI C6000 target:

• Target configuration--Real-Time Workshop general options
• TLC debugging--Real-Time Workshop general options
• General code generation options--Real-Time Workshop general options
• General code generation options (cont.)--Real-Time Workshop general options
• TI C6000 target selection--target specific options
• TI C6000 code generation--target specific code generation options
• TI C6000 compiler--target specific options
• TI C6000 linker--target specific options
• TI C6000 runtime--target specific options

When you select your target in Target Configuration, the options change in the list. For the Embedded Target for TI C6000 DSP, the target to select is ti_c6000.tlc. When you make the change, the options that apply just to TI hardware get added to the list as shown.

The following sections present each Real-Time Workshop category and the options available in each.

Setting Real-Time Workshop Build Options for C6000 Hardware

Target Configuration Options