Embedded Target for Motorola MPC555

Hardware and Software Requirements

Host Platform

The Embedded Target for Motorola MPC555 supports only the PC platform.

Hardware Requirements

Programs generated by the Embedded Target for Motorola MPC555 can run on any Electronic Control Unit (ECU) that is based on the MPC555 processor.

In this document, however, we assume that you are working with the Phytec phyCORE-MPC555 development board, and we document specific settings and procedures for use with the Phytec phyCORE-MPC555 board, in conjunction with specific cross-development environments.

If you use a different development board, you may need to adapt these settings and procedures for your development board.

Software Requirements

See Related Products for information on MathWorks products required to use Embedded Target for Motorola MPC555.

In addition to the required MathWorks software, a supported cross-development environment is required. The Embedded Target for Motorola MPC555 currently supports the cross-development tools listed below; please read carefully the limitations noted:

• Wind River Systems Diab cross-compiler, and Wind River Systems SingleStep debugger (version 7.6.2)

• The full feature set (PIL, RT, and AE targets) is supported when used with the Diab cross-compiler and SingleStep debugger.

• Metrowerks CodeWarrior for Embedded PowerPC (version 6.0 or later)

• Due to current limitations of the Embedded Target for Motorola MPC555, (not of Metrowerks CodeWarrior), only the PIL and AE targets are supported for use with Metrowerks CodeWarrior. The RT target is not currently supported for use with Metrowerks CodeWarrior.

Before using the Embedded Target for Motorola MPC555 with any of the above cross-development tools, please be sure to read and follow the instructions in Setting Up and Verifying Your Installation.

Applications for the Embedded Target for Motorola MPC555

Setting Up and Verifying Your Installation