Getting Started

Configuring the Signal To Workspace Block

To configure the Signal to Workspace block, follow these steps:

1. Double-click the block to display its mask.
2. Type hammcode_BER in the Variable name field.
3. Type 1 in the Limit data points to last field. This limits the output vector to the values at the final time step of the simulation.
4. Click OK.

When you run a simulation, the model sends the output of the Error Rate Calculation block to the workspace as a vector of size 3, called hamming_BER. The entries of this vector are the same as those shown by the Error Rate Display block.

Sending Data to the MATLAB Workspace

Viewing the Error Rate Data in the Workspace